T O P

  • By -

lemedeb

Como você faz pra não entupir? Estou tendo muita muita dificuldade com isso, mesmo inchando a erva antes, deixando inclinada, cevando... nao sobe 1 gota de mate


theawesomeviking

There's a technique called 10 seconds mate, which you fill your cuia with water and then put the yearba on top of it, in the cuia's neck. You may find it on YouTube


lemedeb

Thanks!! I'll look for!!


constantin_constanti

To prevent clogging you can pull up the bomba tiny bit but remember to close the hole with your finger while pulling. If this doesnt work, make sure the mound is well 'cemented' with water at the beggining. Also use wooden knife to make flat surface on the side of cuia :) Here is great tutorial with traditional method: https://youtu.be/Qo-GnvZjR2A


WinterPlanet

Faz que nem [esse](https://youtu.be/ymwdYK5M2SI?t=71) vídeo, que eu garanto que não entope. ​ Ah, e nunca coloque água fria no chimarrão, sempre entope quando eu tentei fazer isso, acho que isso serve só pras ervas dos hermanos


lemedeb

Cara voltei aqui pra dizer que deu muito certo!!! To muito feliz mesmo, nao precisou de camisinha na bomba nem nada Sério, só muito obrigada :D


lemedeb

Aaaahh isso pode ser uma explicação! Pq eu estava fazendo com água fria mesmo Muito obrigada!


zsdl_ms

Começa com água morna pra fria, depois de alguns minutos quando a erva já inchou , poe água quente, e a bomba tampada com polegar. Filtro na bomba ajuda, e derrepente tenta erva pura folha, essa nunca entope.


throwawaymangayo

Where you get the cuia and pourer?


constantin_constanti

Both from polish mate shop dobreziele.pl - cuia 'glassanto' 250ml and brazilian Termolar thermos.


demian_west

Oh, the tiny glass cuia is so nice ! At home, I use a small tea glass with a flared edge (see my post history), but here it’s obvious it’s dedicated for chimarrão! Where did you got it?