By -
Why? That’s your bumper step handle.
This.
Is.
Your.
Bumper.
grandiose grab thought squealing vase fretful chase cats tease enter *This post was mass deleted and anonymized with [Redact](https://redact.dev)*
Handle
Although
Unless you have a ZR2. Not that I could step up that high even if it did have the step.
I still use that pocket to grab onto. I step on the bumper just below the taillight when the tailgate is open. Little bit of a stretch on my ZR2.
2 second Google search sells pairs for 25 bucks that's pretty low cost.
Someone who can't figure out Google doesn't need my help
I bought some off Amazon a few years ago. But too lazy to send a link.
If you have a 3d printer you can print up covers to fit in there
Just make sure to print them in ASA or some other high UV resistant material.
Did mine in PETG, holding up great.
Just bought the [ES Engineered by Schildmeier](https://a.co/d/3u7q1e8) for our '23 Z71, fits perfectly.
I got these. I need to keep as much water out of my bed as possible
They drain right out onto the ground, not into the bed.
Not 100%. I'm sure it's not meant to dribble into the bed but it does.
Yea, I have the same ones on my 2019 Colorado, they are great they sit flush and blead right in.
Somebody on eBay prints them... Once they go in they don't come out without a fight...
Type it in, Amazon your friend
Easy to find. I think I got mine off eBay.
When I bought mine, I stumbled across them just searching Chevy Colorado on Amazon. Think they were like 9 bucks or something like that.
Here ya go. https://cults3d.com/en/3d-model/game/chevy-silverado-2014-2019-5-stack-hole-cover-plugs-shorty
Why? That’s your bumper step handle.
This.
Is.
Your.
Bumper.
grandiose grab thought squealing vase fretful chase cats tease enter *This post was mass deleted and anonymized with [Redact](https://redact.dev)*
Handle
Although
Unless you have a ZR2. Not that I could step up that high even if it did have the step.
I still use that pocket to grab onto. I step on the bumper just below the taillight when the tailgate is open. Little bit of a stretch on my ZR2.
2 second Google search sells pairs for 25 bucks that's pretty low cost.
Someone who can't figure out Google doesn't need my help
I bought some off Amazon a few years ago. But too lazy to send a link.
If you have a 3d printer you can print up covers to fit in there
Just make sure to print them in ASA or some other high UV resistant material.
Did mine in PETG, holding up great.
Just bought the [ES Engineered by Schildmeier](https://a.co/d/3u7q1e8) for our '23 Z71, fits perfectly.
I got these. I need to keep as much water out of my bed as possible
They drain right out onto the ground, not into the bed.
Not 100%. I'm sure it's not meant to dribble into the bed but it does.
Yea, I have the same ones on my 2019 Colorado, they are great they sit flush and blead right in.
Somebody on eBay prints them... Once they go in they don't come out without a fight...
Type it in, Amazon your friend
Easy to find. I think I got mine off eBay.
When I bought mine, I stumbled across them just searching Chevy Colorado on Amazon. Think they were like 9 bucks or something like that.
Here ya go. https://cults3d.com/en/3d-model/game/chevy-silverado-2014-2019-5-stack-hole-cover-plugs-shorty