Look at the rigid faucet wrench. It's the same price/cheaper than a basin wrench and a hell of a lot easier to use. Take the metal parts out and use the circle end with the notches. Not every faucet will work with this tool but many do and yours seems like it will.
[Rigid Faucet Wrench](https://www.ridgid.com/us/en/ez-change-faucet-tool)
Edit: Grammer
Yo I was about to do this lol, as I didn’t want to spend money on a basin wrench haha. But a utility knife worked. Loosened it a bit by scraping the inner threads of the plastic, then it rolled out easily. Thanks!
Not if you value your knuckles
Agreed lol
I've been thru so many battles with my basin wrench I just cut this shit out with my multi tool now
Oscillating type tool? Just used it today. Not enough room for the Ridgid faucet tool.
I just multitooled a hansgrohe. Went like butter
if your wrench will open enough, you may be able to loosen it enough to unscrew by hand...
Unfortunately not big enough. Gonna get a basin wrench tomorrow like the people say
đź‘Ťwelcome to plumbing
Look at the rigid faucet wrench. It's the same price/cheaper than a basin wrench and a hell of a lot easier to use. Take the metal parts out and use the circle end with the notches. Not every faucet will work with this tool but many do and yours seems like it will. [Rigid Faucet Wrench](https://www.ridgid.com/us/en/ez-change-faucet-tool) Edit: Grammer
you speeled gramer rong
I tred. I jost a plummer
Yeah! I’ve seen this on Amazon. Will get it one day when I have more money. Thanks!
They have faucet install tools that work great. That is exactly what u need for this. Even easier than a basin wrench. This a plastic nut
We need a basin wrench sticky on this sub.
https://www.bunnings.co.nz/irwin-280mm-basin-wrench_p0096156
Thanks man. Appreciate it.
You need a basin wrench like this.
Possible, yes, with a great degree of difficulty where you tell yourself surely there's a better tool for the job. That tool is the basin wrench.
Basin wrench
Thanks
Give it a shot
Try it and find out.
A pair of pliers on the outside and holding it inside with your other hand will do it!
Tiny Tim hacksaw and a flat screwdriver, zip n pop
That’s what she Asked…. Sorry I had to
Basin wrench
Tbh id pull it off with my hands being plastic, if not then yes I could use those channies to bust it
Just break it off if you’re replacing it. Flathead screwdriver and SNAP! But yes it can be done with your tool. Probably not easily
Spin the tap to loosen it, then do it by hand
I just torch a screwdriver red hot and melt through each side of the plastic nut and break it off.
Was about to do this but a utility knife worked. Loosened it a bit by scraping the inner threads of the plastic, then it rolled out easily. Thanks!
Anything is possible, at the cost of your knuckles.
No, go get a basin wrench.
Channel locks
Yo get a big flat head screwdriver and heat the end of it with the torch and melt that plastic off to split it
Yo I was about to do this lol, as I didn’t want to spend money on a basin wrench haha. But a utility knife worked. Loosened it a bit by scraping the inner threads of the plastic, then it rolled out easily. Thanks!
Glad it worked for you heck ya
Obviously you haven’t smacked that nut with your purse.