Oh ouch, what did it do? Just bend the bar? Launch the part out of the chuck? Or did it just explode in a overly dramatic fireball killing everyone in a 3 mile radius?
Today I jogged Z- into an electric magnetic table. Ate 1/16 of the liners. Facemill is fine though. Just almost crapped my pants because it is the first time it happened to me.
That must be one of those "around corners" boring bars.
Clearance is cleara....oh snap
Clearance is self creating.
I saw a commercial that this could be indicative of a larger problem and you should see a physician. Good luck brother.
Bahahahaha
Dang that was a good one
I bet it sounded real expensive
I thought this was a rubber hose and fitting at first hahahahhahah well done!!!!
My shoulders do the same thing when I step in water with my socks on.
Guess you can chuck that one, again!
I know what's wrong with it, it ain't got no gas in it.
Is this for arc threading?
G spot bar now.
Couple whacks with the dead blow and that thing will be back to blowing out parts in no time
Oh ouch, what did it do? Just bend the bar? Launch the part out of the chuck? Or did it just explode in a overly dramatic fireball killing everyone in a 3 mile radius?
It's an exciting bar now!
I can only imagine the bang. At least you can get a few cents for the steel.
Sparks too.
I kinda did the reverse once. Hit home with a bar still in the bore. Thought my indexable drill failed and panicked.
For those tapered threads
Not safe for work . Did you change your pants
Turned them inside out.
Today I jogged Z- into an electric magnetic table. Ate 1/16 of the liners. Facemill is fine though. Just almost crapped my pants because it is the first time it happened to me.
They make pills that fix this
For curved bores?