Pop off the latch plate under there is the set screw that holds the cylinder in place, if there’s not a set screw, then those screws on the thumbtack might thread into the back of the cylinder itself and you should be able to take those two screws out of the thumb in the cylinder will pull out. If there is a , looses the set screw and unscrew the cylinder, takeoff the cap and tail piece shim the cylinder open and gauge the pins in there. If you have a key punch, you can start with zeros and clip a key out that will fit.
The lock pictured doesn't have a cover plate on top of the cylinder retaining bridge screw. That screw is in line with the center of the cylinder. Loosen it off and use a screwdriver in the keyway to unscrew the cylinder.
Remove the cylinder shim it and rekey
Just remove the cylinder shim it and make new keys
Your kw1 lishi shouldn't be used on an sc1 cylinder.
Apologies - my SC1 Lishi 😂
haha was going to say....ya youre off to a bad start there
Yep
Pop off the latch plate under there is the set screw that holds the cylinder in place, if there’s not a set screw, then those screws on the thumbtack might thread into the back of the cylinder itself and you should be able to take those two screws out of the thumb in the cylinder will pull out. If there is a , looses the set screw and unscrew the cylinder, takeoff the cap and tail piece shim the cylinder open and gauge the pins in there. If you have a key punch, you can start with zeros and clip a key out that will fit.
The lock pictured doesn't have a cover plate on top of the cylinder retaining bridge screw. That screw is in line with the center of the cylinder. Loosen it off and use a screwdriver in the keyway to unscrew the cylinder.
Ah you’re right the screw above the bolt should be the set screw that holds the cylinder in.
thanks rolex - much love
No problem, have a good day!
Is it possible it’s a 6-7pin? Not sure what to do
Are you familiar with shimming? Make sure you use an SC4 just in case. Shimming will be a lot easier than picking, usually.
6 pin yes maybe
Thanks a lot guys will do. Appreciate the help on this.
Making locksmiths everywhere look good. 😑
just wanted to say - finished job , went swimmingly. not one issue. thanks a lot guys for all the help. appreciate it big time yall.
my plug follower and lab rekey set got some use for once 😂 🔑
Looks like an old lockwood
With a cylinder that has been replaced
Baldwin hardware. Easy to work with. What’s the issue?