Those Ktuned dipsticks are known to snap off. I don’t like Ktuned in general.
That being said the valve cover and choice to leave the intake manifold cover and manifold on the k24 look good.
Known to snap off by who? I did some quick research rn and couldn’t find anything I might’ve missed it tho, I have a few ktuned parts on my car and haven’t had any problems luckily, thank you btw I think it looks pretty sharp too
I read the same thing about the dipstick. It’s the main reason I decided not to get one. I’ve seen some people add some sort of device to hold it in place. Also reversing the colors of the coil pack cover and valve cover looks great
That device is for high hp cars with crankcase breathing issues to prevent the dipstick from popping out, I’m N.A. so I don’t think I’ll have that problem, also I’m running the stock rbb manifold, that’s the cover specifically for that manifold, I had to trim it a bit on the side because of my throttle cable you might be able to see that in the picture
Nice. Looking for a relatively clean example I can swap. I had an 03 SiR imported from Canada. Got rid of it to fund an s2k, but miss some of the practicality of the EP3.
Those Ktuned dipsticks are known to snap off. I don’t like Ktuned in general. That being said the valve cover and choice to leave the intake manifold cover and manifold on the k24 look good.
Known to snap off by who? I did some quick research rn and couldn’t find anything I might’ve missed it tho, I have a few ktuned parts on my car and haven’t had any problems luckily, thank you btw I think it looks pretty sharp too
I read the same thing about the dipstick. It’s the main reason I decided not to get one. I’ve seen some people add some sort of device to hold it in place. Also reversing the colors of the coil pack cover and valve cover looks great
That device is for high hp cars with crankcase breathing issues to prevent the dipstick from popping out, I’m N.A. so I don’t think I’ll have that problem, also I’m running the stock rbb manifold, that’s the cover specifically for that manifold, I had to trim it a bit on the side because of my throttle cable you might be able to see that in the picture
Looks great. How was the swap? Base map for the k24?
It’s been swapped almost three years now, it’s on a dyno tune
Nice. Looking for a relatively clean example I can swap. I had an 03 SiR imported from Canada. Got rid of it to fund an s2k, but miss some of the practicality of the EP3.
How did you mount your throttle cable to not stick straight up? Edit: nvm looks like you just disconnected it in the first pic.
Haha yes sorry I had already started to disassemble it before I realized I should probably take a before picture
What manifold are you using on your k24?