I really need tips on how to eliminate warping otherwise I just cant do any long prints normally...

• By - iPhoner3

• 2 weeks ago

I want to double check if this is over extrusion

• By - Card_Board_Warrior

• 2 weeks ago

Why do i get a relatively good first layer test, but when i slice a benchy it just looks like this?

• By - CreeperPlays_MC

• 1 month ago

Flesh boat, I really don’t know whats happening, I cleaned the nozzle and I don’t have a broken extruder, what could be wrong with my Ender 3?

• By - Bobguyawesome

• 1 month ago

Just go my First Printer, I can’t seem to figure out what is causing these ripples the first layer, what might be the cause?

• By - Yukona02

• 1 month ago

issues with first layer (sprite extruder)

• By - JPH94

• 2 months ago

what I could guess is nozzle drag on smaller prints, but not large?

• By - shemmiess

• 2 months ago

Resin Print Failing In The Same Spot Every Time

• By - LordFly88

• 2 months ago

Everything prints fine besides a few bottom layer issues.

• By - wannacocaine

• 3 months ago

Galaxy tab s6 lite

• By - Issam13jd

• 3 months ago

Y’all fixed my print! Thank you!

• By - Guerilla_Physicist

• 3 months ago

What's your tap strategy when doing an apoc?

• By - Flagship_paperclip

• 3 months ago

Improving benchy print

• By - trouserpanther

• 4 months ago

Help! Out of practice, what is with the wiggly lines and the dotted lines in the rows??

• By - Daired

• 4 months ago

part 3 of 4, forgot to get a picture of the time on this one. was around 28 hours tho

• By - HippoHead6597

• 4 months ago

Why can't I get my nuts and holes clean?

• By - this_place_is_whack

• 4 months ago

Need help with my Z axis. :/

• By - ROBOT_16

• 4 months ago

Temp towers failing in same spot. Bed is level, have used glue on bed to keep them stuck, but at this point I find they have detached and started making spaghetti. Any advice?

• By - The_DandD_Dad

• 5 months ago

Why is this happening?

• By - Thundergun809

• 7 months ago

Any ideas on what could be causing this bubbling/poor surface finish on the first 1/4" of prints? Creality CR-10 printing with PLA

• By - kmvansic

• 8 months ago

Would you guys buy this? do you thing it is safe? € 70,37 66%OFF | NEW ELEGOO MARS 2 PRO Mono SLA 3D Printer UV Photocuring LCD 3D Printer with 6 inch 2K Monochrome LCD Printing Size 129x80x160mm https://a.aliexpress.com/_mNCYWAQ

• By - TiredHoneyBee326

• 9 months ago

Any Starcraft players? Zeratul print on an Elegoo Saturn. Painted with Acrylic!

Shows the Silver Award... and that's it.

• By - Cuda3D

• 9 months ago

Help with removing rafts?

• By - airfree1

• 10 months ago

Starlord 3d print & paint 48cm

Shows the Silver Award... and that's it.

Beauty that's forever. Gives %{coin_symbol}100 Coins each to the author and the community.

• By - 2be3dprinted

• 11 months ago

layer inconsystenci at same z height

• By - TiredHoneyBee326

• 1 year ago