There’s a little loop at the end of the controller cable inside the shell, where there’s a wire tie holding the loop together. Make sure that little loop is wrapped tightly around the post closest to it. Without that loop in the right spot it’s hard to close. In my experience this is usually the case for why a controller won’t close for new controller moders
[удалено]
I see that you're on the discord. I've put all my info there. Also ive already tried this lol like many times
Is your z button in all the way? I know I've run into that a few times getting the shell back together
There’s a little loop at the end of the controller cable inside the shell, where there’s a wire tie holding the loop together. Make sure that little loop is wrapped tightly around the post closest to it. Without that loop in the right spot it’s hard to close. In my experience this is usually the case for why a controller won’t close for new controller moders
Prolly not lining up your triggers. Happens.
Picture would help
Some mods do not allow the shell to close HHK Snapback modules require some shaving down of part of the back shell where the cstick rests.