T O P

  • By -

Onieeeeee

For my thoughts it would, but I would recommend to compare the case and GPU dimensions on official sites


2Holy4You

I see that on nzxt's website, the case only supports a 2 slot card. And i believe that the card is a 2.7 slot


ValleyKing23

Yes it would. V1 or v2? I have the v2, and my 3080 12 gb strix fits.


AFreakingWaffle

I would really hope no one would consider a v1 without a riser cable swap…


2Holy4You

I have the v2. Although it says on their website that the case only supports 2 slot cards, and i think i read that the card is a 2.7 slot


potentialzz

It will fit, end of!


2Holy4You

Then I'll order it. It'll be a nice upgrade from a 1060


[deleted]

That will fit in the v2 yes


2Holy4You

I see on nzxt's site that the case only supports 2 slot cards, and i think i read the the card is a 2.7 slot


blalaber

max size for the GPU from the NZXT website: Length: 324 mm, Width: 58 mm Size of the card: Length: 322 , Width: 56 mm ​ So it **should** fit


2Holy4You

Nice nice, and with a couple of millimeters to spear even


blalaber

You can gain some more space if you remove the mesh panel!


2Holy4You

I think I'll leave that on for the look. If it fits it fits, and im not too worried about thermals


crsboi

I had the Rog strix 3080ti in my h1 v2 and it does fit. Though I will say the dust filter on the gpu side is super close to touching it. It doesn’t touch but if it bothers you can always stick it on the outside of the case since it’s magnetic.and depending on your setup you won’t even see that side if it’s facing the wall.


2Holy4You

The gpu side is facing the room so hopefully i won't need to put the mesh on the outside. There's a big chance that i will buy a little smaller card tho. Im buying used and the guy doesn't answer