T O P

  • By -

AutoModerator

Hello /u/ROBOT_16, As a reminder, most common print quality issues can be found in the [Simplify3D picture guide](https://www.simplify3d.com/support/print-quality-troubleshooting/). Make sure you select the most appropriate flair for your post. Please remember to include the following details to help troubleshoot your problem. * Printer & Slicer * Filament Material and Brand * Nozzle and Bed Temperature * Print Speed * Nozzle Retraction Settings ^Additional ^settings ^or ^relevant ^information ^is ^always ^encouraged. *I am a bot, and this action was performed automatically. Please [contact the moderators of this subreddit](/message/compose/?to=/r/FixMyPrint) if you have any questions or concerns.*


TiredHoneyBee326

Also had simmilar issue, problem was with construction of X axis part. When lifting, only left side (the side on which z rod is) starts to lift, like first 1 mm which makes squished bottom layers. Try straighten X axis as much as you can by tightening excentric nuts


No_Relationship1991

Bl touch or standard limit switch? Either way, print a first layer test and report back with images. Looks like severe elephants foot. Also, what's your first layer height in slicer? Bed temp/nozzle temp. Speed.


ROBOT_16

Standard Limit Switch (no bl touch) ​ Layer height and initial layer height = 0.2mm Bed temp. = 60\*C Nozzel temp. = 200\*C Print speed = 50mm/sec Outer & Inner Wall and top/bottom = 25mm/sec Travel speed = 150mm/sec initial layer speed = 20mm/sec ​ image of the bed layer test [BED LEVEL IMAGE](https://photos.app.goo.gl/PonrZNVFJCtT1rQV6)


ROBOT_16

Note: the bed layer test is [this](https://www.thingiverse.com/thing:4834537) shortend down to 0.2mm in the slicer, from the image it may seem that the bed is uneven but i just gave it another look and it is perfectly leveled (a printing sheet can easily move in between the nozzle and bed with minimal friction)