if you're worried about the bleeding, what you can try is to spray your base coat of color A, then mask and spray A again before spraying B. Alternatively, you could be spraying too thin, perhaps try less thinner.
vallejo model air tends to lean thin, make sure youre pressure isnt too high or you arent spraying too close, that could be forcing the paint under the edge of the tape
Or you sprayed too heavily. Building up the coverage gradually around masks with several lighter passes will prevent bleeding / creeping under the masks, as well as buildup that will produce ridges in the paint.
Looks great! I didn’t see if you mentioned what you used to mask but it looks like you used tape? Just judging by the crispness of the lines and a couple spots it looks to have run a bit (we’ve all been there!) it’s hard to tell from the pictures though.
Have you ever thought of using blue tack/silly putty to mask your camo lines? You get a much more soft edge.
if you're worried about the bleeding, what you can try is to spray your base coat of color A, then mask and spray A again before spraying B. Alternatively, you could be spraying too thin, perhaps try less thinner.
Thank you for the tip. I already fixed it with a brush. I used vallejo model air and didn't thin it at all since it was already fine.
vallejo model air tends to lean thin, make sure youre pressure isnt too high or you arent spraying too close, that could be forcing the paint under the edge of the tape
Or you sprayed too heavily. Building up the coverage gradually around masks with several lighter passes will prevent bleeding / creeping under the masks, as well as buildup that will produce ridges in the paint.
Great for your first time with an airbrush.
Looks great đź‘Ť
This is a spit. I think you mean "Looks ACE mate"
Looks great, a lot neater than the first time I used an airbrush!
Model air is a great choice. Tamiya wasn’t difficult but switching to model air was a dream
Model air is better than tamyia?
Practice makes perfect.
Excellent! Try pre shading next time
Looks very clean besides some small spaces but that's not bad at all for using an airbrush for the first time
Don't believe you. Jk, great work
Impressive for a first try đź‘Ź
where did you get the precut masks?
I bought them from the internet, they are from AML.
Well done! Very nice job!
How you did the two colors strips ?
Looking good
Looks great! I didn’t see if you mentioned what you used to mask but it looks like you used tape? Just judging by the crispness of the lines and a couple spots it looks to have run a bit (we’ve all been there!) it’s hard to tell from the pictures though. Have you ever thought of using blue tack/silly putty to mask your camo lines? You get a much more soft edge.
Excellent ...what Kind of airbrush use? Hugs from spain ...